ASSEMBLY INSTRUCTIONS
4
B5
B5
NOTE: The horizontal center of the Beams (B1, B2) should
B5
4.1. As shown in the figure, fix the screws T-Nut (MM) onto the lintels. Knock the T-Nut (MM) into
the lintel, making sure the T-Nut (MM) are flush with the lintel.
4.2. Connect the already connected beam (B1/B2) and the already connected beam (B3/B4/B5) to
the connector (D1) in the middle with bolts (CC), washer (VV) and cap (SS).
B2
B5
be aligned with that of the Beams (B3, B4, B5).
B4
B4
B4
B4
13
B3
B3
B1
B3
SS
CC
VV
B3