Safety Instructions; General Information; Working With The Device; Intended Use - IKA Rotastand Manual De Instrucciones

WARNING
CAUTION
NOTICE
!
/// General Symbols
Position number
A–––
Indicates device components relevant to actions

Safety instructions

!

/// General information

› Read the operating instructions completely before starting up and follow the safety
instructions.
› Keep the operating instructions in a place where it can be accessed by everyone
› Follow the safety instructions, guidelines, occupational health, safety and accident prevention
regulations
/// Device setup
› Set up the device in a spacious area on an even, stable, clean, non-slip, dry and fireproof surface
› All screw connections must be properly tightened
› Check the mounting position of the viscometer to avoid the danger of the unit tipping over

/// Working with the device

Notice!
!
› Risk of tipping exists when tilted the stand at an angle of being over 10° with full load
› Observe the maximum permissible load-bearing capacity (see "Technical data")
› When moving the stand, ensure the device is at the lowest end stop position
› When used as intended and in accordance with the operating instructions, there is no danger
to people, the environment or the device The manufacturer cannot be held responsible for any
damages as a result of incorrect use of the device or non-compliance with the safety instructions
/// Accessories
› Protect the device and accessories from bumping and impacting
› Check the device and accessories beforehand for damage each time when you use them Do
not use damaged components

Intended use

/// Use
› The IKA Rotastand has been designed for holding, lifting and lowering IKA Rotavisc
10
Indicates a hazardous situation, which, if not avoided, can result in
death, serious injury
Indicates a potentially hazardous situation, which, if not avoided, can
result in injury
Indicates practices which, if not avoided, can result in equipment damage