Würth Master RW 160 Instrucciones Para El Manejo página 7

RW 160 - GB Seite 7 Mittwoch, 14. April 2004 2:04 14
GB
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein are strictly
followed. In addition, the general
safety notes in the enclosed book-
let must be observed.
The machine must not be wet and
must not be operated in a moist envi-
ronment.
If the mains cable is damaged or cut
through while working, do not
touch the cable but immediately pull
the mains plug. Never use the
machine with a damaged cable.
Wear protective glasses.
For long hair, wear hair protection.
Work only with closely fitting clothes.
Dust developing during the mixing
procedure is harmful to one's health.
Wear a dust protection mask.
Connect machines that are used in the open via a
residual current device (RCD) with an actuating
current of 30 mA maximum. Use only extension
cables that are approved for outdoor use.
Tool Specifications
Stirrer
Order number
Rated power
Output power
Rotational speed under load
- 1. gear
- 2. gear
Tool holder
Stirrer Ø
Weight (without acces.), approx 5.7 kg
Protection class
For Your Safety
For food-hygienic reasons, only stirrers/mixers
with stainless steel stirrers and special grease
lubrication may be used in the food industry.
Therefore, this stirrer/mixer may not be used for
the mixing of food stuffs.
Use the machine only with the auxiliary handle 5.
Always direct the cable to the rear away from the
machine.
Do not carry or hang up the machine by the cable.
Insert the mains plug only when the machine is
switched off.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Observe the reaction torque of the machine.
Explosive materials, e.g., easily inflammable sol-
vent and similar materials with a flash point
below 21 °C must not be processed.
During the mixing procedure, do not reach into the
mixing container with your hands or any objects.
Provide for a firm and secure stand of the mixing
container.
If the machine fall into the material to be stirred,
pull the mains plug immediately and have the
machine checked by an after-sales service agent.
Always switch the machine off and wait until it has
come to a standstill before placing it down.
Do not drill into housing or attach rivets in order to
mark the machine. The double insulation is then no
longer ensured. Use stickers.
Use only original Würth parts and accessories.
For further notes on safety refer to the enclosed sheet
1 Stirrer
RW 160
2 Drive spindle
0 702 836 X
3 Gear selector switch
1300 W
4 On/Off switch
710 W
5 Hand guard/auxiliary handle
6 Screw
7 Allen key
0 – 300 rpm
Not all of the accessories illustrated or described are included
0 – 560 rpm
as standard delivery.
thread size M 14
(female thread)
max. 160 mm
/ II
Operating Controls
7