Publicidad
Idiomas disponibles
Idiomas disponibles
Once the desired parameters have been determined, press the
ON button and give intensity to start treatment.
Press [ON/OFF/M] button to return to the standby mode.
6.11 Load detection
If the electrodes do not adhere perfectly to the skin, perhaps
because they are worn, or if the leads are not connected to the
device, above intensity level 5, the device will detect the ano-
maly by resetting the intensity and at the same time the symbol,
, of the reference channel will flash for about 4 se-
ot
2
1
conds. Then the stimulator will return to standby mode as shown
below::
6.12 Low battery detection
When the battery is low, the
the
i
icon will twinkle to indicate it,
stop the device and charge the battery.
Tesmed copyright - it is absolutely forbidden the partial or total reproduction of any present content
71
Publicidad
