babybay Boxspring 166153 Instrucciones De Montaje página 13

IMPORTANT - PLEASE READ
EN
CAREFULLY AND KEEP FOR FUTURE
REFERENCE
Assembly:
1. Assemble the three frame parts (parts a, b, c). upside
down so that the large holes on the bottom of the
pieces face up.
2. Screw the 4 bolts (part 1117) into parts c and b until
finger tight. The hole in the bolt must face upwards, if
it does not face upwards, unscrew the bolt slightly
until it faces upwards. (The bolts may be a little loose)
3. Insert the 4 housings (part 1116) into parts c and b as
shown.
4. Put the frame parts a, b, c together so that there is no
gap between them. If the bolts (part 1117) do not fit
easily into the corresponding holes, make sure the
housings have not rotated in the holes.
5. Insert the 4 grub screws (part 1122) into the housings
that are already in parts a and c. Use a Phillips
screwdriver to tighten the grub screws clockwise (min.
1.5 Nm max. 2.5 Nm ).
6. Place the lying surface (part d) so that the large holes
all around point upwards. Press the 4 fastening jaws
(part y) into the lying surface with the wooden dowels
as shown in the picture.
7. Secure each of the 4 mounting jaws (part y) with a
screw M6x40mm (part 1211) and the included Allen
key (part 1200) in a clockwise direction as shown. The
screws must be tightened hand-tight (min. 1.5 Nm -
max. 2.5 Nm ). Do not overtighten the screws.
8. Lay frame parts a, b and c flat on the floor as shown.
Position the lying surface (part d) so that the 4
fastening jaws (part y) point towards the underside of
the babybay.
9. Attach 2 of the counterparts (part z) with one
M6x40mm screw (part 1211) each to the fastening
jaws (part y) on the lying surface (part d) with the
Allen key (part 1200) as shown (min. 1.5 Nm -
max.2.5Nm). Then place the babybay on the bottom
side of the frame and attach the 2 other counterparts
(part z) to the back using the same method. The
screws must be tightened hand-tight (min. 1.5Nm -
max. 2.5Nm). Do not overtighten. (The height of the
lying surface must be adjusted later).
10. The minimum measurement between the top of
the lying surface and the bottom edge of the frame
(as shown) is 27.5 cm.
11. Adjust the height of the babybay ‚s lying surface so
that the babybay mattress is at the same height as the
parents' bed mattress.
12. Remove the top parent bed mattress. Place the straps
from the mounting plate across the parents' bed. The
mounting plate must be on the opposite side of the
babybay as shown. The straps must not be twisted.
Attach the straps to the two front bars of the babybay
using the plastic clips .
13. Place the upper parent bed mattress back on the base
frame. Pull the belt loops as shown with at least 300
Nm so that the babybay pulls itself firmly against
the parents' bed. Check whether the babybay is
securely attached to the parents' bed by pulling it
firmly backwards . There should be no gap between
the two beds .
13