Fronius RC Pedal TIG /TMC Manual De Instrucciones página 22

Start-up
RC Pedal TIG /
1
TMC: connecting
the remote con-
trol
2
When the remote control is connected, the remote control symbol is displayed in
the status bar on the power source.
The 2-step, 4-step and spot welding modes can no longer be selected.
RC Pedal
1
TIG /BT: connec-
2
ting the remote
control to the
power source via
Bluetooth
3
Risk of injury and damage from unexpected arc ignition!
Unexpected ignition can be triggered by another pedal remote control connected
to the power source.
▶
▶
Beware when switching the remote control on/off:
Leave the remote control for at least 3 seconds after switching off, otherwise the
switch off will not be detected.
If the device is switched on again too quickly after it has been switched off, the
status LED illuminates for less than 3 seconds.
22
For TIG applications only:
Disconnect the TIG welding torch plug from the TMC connection on the
power source
Switch on remote control at the bottom
Switch on power source and activate Bluetooth function
The remote control is ready to use when this is detected and displayed by the
power source.
Confirm Bluetooth settings on the power source if necessary
CAUTION!
Make sure that the correct pedal remote control is connected to the power
source!
Check MAC address!
TMC
1
2