Fronius RC Bar iJob / TMC Manual De Instrucciones página 15

General
Safety
Device concept
Requirements The remote control can be used with the following power sources:
-
Options
TIG Multi Connector extension 5 m
WARNING! Incorrect operation and incorrectly performed work can cause seri-
ous injury and damage to property. All work listed in this document may only be
performed by trained specialist personnel. All functions described in this docu-
ment may only be used by trained specialist personnel. All work and functions de-
scribed may only be performed and used once the following documents have
been read and understood in full:
- This Document
- All Operating Instructions for system components, especially the safety rules
TPS 320i - 600i used with a WF 25i/30i wirefeeder with integrated optional connection
OPT/i WF TIG Multi Connector
With the remote control RC Bar iJob / TIG
Multi Connector the same parameters can
be set like with a JobMaster welding torch.
43,0004,5979
15