Publicidad
Idiomas disponibles
Idiomas disponibles
10. Automated Learning Process./Activating Code.
CAUTION: The remote control can be programmed to
REMOTE CONTROL
(back)
multiple receivers or fans. If this is not desired, turn
wall switch off to any other programmable receiver or
fan.
Remove battery cover on back side of remote
control. Install one 12-volt battery (included).
battery
Restore electrical power. Within 60 seconds of
restoring the power, press and hold the fan SET
button for 5 seconds or until light blinks three
SET
times. Then replace the battery cover.
NOTE: Remove batteries with low or no charge and
dispose of properly.
IMPORTANT: Store the remote control transmitter
battery
away from excess heat or humidity. To prevent
cover
damage to remote control transmitter, remove
battery if remote control transmitter will not be
used for long periods.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK. " - When
I I I
IV
disposing of household alkaline batteries, it is best
V
I I
to check with your local and state recycling or
VI
I
household hazardous waste coordinators
concerning the specifics of the program in your
area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or
visit www.epa.gov/recycle or www.earth911.org for
more information.
REMOTE CONTROL
WARNING: Choking Hazard - Small parts. Keep
(front)
battery away from children.
WARNING: Non-rechargeable batteries are not to
be recharged; Do not mix different types of
batteries such as alkaline, carbon-zinc, or
rechargeable batteries; Do not mix old and new
batteries; Batteries are to be inserted with the
correct polarity; Exhausted batteries are to be
removed from the product.
page 9
Publicidad
