STARLINK Ridgeline Manual Del Usuario página 13

INSTALLATION
Instructions
Unplug your Starlink before beginning the installation process.
The four ballast pieces are required when installing the Ridgeline Mount.
1. Carry the Ridgeline Mount to the roof's peak.
2. Rotate knob ~90 degrees counterclockwise
to loosen the center arm.
3. Unfold and place the mount on top of the roof's peak,
with each tray resting on either side of the roof.
4. Adjust the mount to ensure each tray is flush to the roof.
5. Orient the center arm within 5 degrees of vertical.
6. Turn the knob clockwise until tight to lock in the center arm's
position. Verify the mount's joint is tight.
ENGLISH
5°