Publicidad
Idiomas disponibles
Idiomas disponibles
C. COMPONENTS
D. ASSEMBLY INSTRUCTIONS
1. Unpack the fan and verify that all components and parts are complete and in good condition.
2. Check the nameplate data on the motor head (11) to verify that the voltage and frequency are suitable for local use.
3. Insert the top cap (3) into the bar (1).
4. Insert the lower cap (5) into the bar (1).
5. Pass the electrical cables (2) through the bar (1) and connect them to the cable terminal block (10).
6. IMPORTANT: MAKE SURE THE FAN GROUND CABLE IS CORRECTLY CONNECTED WITH THE GROUND WIRE.
7. Insert the bar (1) into the hook (8) and secure it with the bolt (6) and slide pin (7). Make sure you tighten the nut
(15).
8. Fasten the lower cap (5) to the bar (1) with the screws (14).
9. Firmly secure the blades (13) to the motor head (11) using screws and washers (12). Remember to put the shock
absorber (16) under the blade to avoid vibrations.
10. Hang the fan on the hook of the hook (FIG.1)
11. Connect the cables (2) to the power supply (220-240V ~ 50Hz) and the earth wire.
12. Fix the upper cap (3) on the upper end of the bar (1) using the fixing screws (4).
E. INSTALLING THE SPEED REGULATOR
1. Remove the regulator cover.
2. Connect the cables through the entry hole according to the diagram in FIG.3.
1. Bar
2. Electric cables
3. Upper shell
4. Locking screw
5. Lower shell
6. Bolt
7. Sliding pin
8. Hook
9. Hook of the hook
10. Wire terminal block
11. Engine
12. Screws
13. Shovels
14. Screws
15. Nut
16. Shock absorber
10
Publicidad
