Publicidad
Idiomas disponibles
Idiomas disponibles
3. Mount the controller on a wall or wooden base.
F. HOOK INSTALLATION (NOT INCLUDED)
Check that the wall where you want to install the fan satisfies the safety requirements and that the distance from a
socket allows for electrical connection.
Avoid positions that would not allow the oscillating movement of the appliance
ATTENTION:
A. Make sure the hook can support a load of no less than 25kg.
B. Do not use non-metallic junction boxes.
C. Do not use lubricant on the single mounting screw.
1. Drill a pilot hole in the ceiling to facilitate hook installation. Make sure the pilot hole is no larger than the minor
diameter of the mounting screw threads.
2. Install the hanger in the ceiling pilot hole with at least 4 cm of the mounting screw threads that fasten into a
structural timber joist to provide secure mounting. Leave a 3cm gap between the hook tip and the ceiling as
shown in FIG. 1.
3. Install the junction box on the ceiling.
ATTENTION:
1. Do not install the blades closer than 2.3m from the floor
2. The appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental abilities, or with a lack of experience and knowledge, unless they have been
supervised or instructed in the use of the appliance by a person responsible for their safety.
11
Publicidad
