Publicidad
Fig. 4
TOP
4. Mark the locations of the screw holes for the Leaf Supports (P) 3-1/16" up on the apron and
3" from the leg. See Figures 4 and 4a. Using a Phillips Head Screwdriver, punch a pilot hole for
each screw. Making sure the long arm of the leaf support is toward the Back Apron (D), attach with
#8x5/8" Pan Head Screws (X). Making sure the top and leaf are level, attach the other end of the
leaf support to the leaf with #8x5/8" Pan Head Screws (X). Repeat for the other side. See Figures
4 and 4a.
Fig. 5
5. Attach the Drawer Handle (T) to the drawer with two #8x1" Machine Screws (ZC). See Figure 5.
6. Determine where you would like the J Hooks (Q) mounted and attach each with two #8x5/8" Pan
Head Screws (X). See Figure 6.
Page 6 — 114Wa — 10/13
D
X
3
1
/
"
16
Q
Fig. 6
P
D
X
LEAF
ZC
T
X
Fig. 4a
Publicidad
