Poulan Pro PP036 Manual De Instrucciones página 8

KNOW YOUR TRIMMER
READTHIS INSTRUCTION MANUAL AND SAFETY RULESBEFORE OPERATING YOUR UNIT
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments. Save this manual for future reference.
Assist Handle
Trimmer
Head
Sha_
Coupler
ON/OFF Switch
Starter
Shield Handle
_ Primer Bulb
Line Limiter
Blade Throttte Trigger
Lever
Muffier
ON/OFF SWITCH
The ON/OFF switch is located on the trigger
handle and is used to stop the engine. Move the
switch to the OFF position to stop the engine.
PRIMER BULB
The PRIMER BULB removes air from the car-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulis on the starter rope. Activate the primer
bulb by pressing it and allowing it to return to
its original form.
CHOKE
The CHOKE he_ps to supply fue_ to the engine
to aid in cold starting. Activate the choke by
moving the choke tever to the FULL CHOKE
position. After the engine attempts to start, move
the choke lever to the HALF CHOKE position.
Once engine has started, move the choke lever
to the OFF CHOKE position.
COUPLER
The COUPLER enables optional attach-
ments to be installed on the unit.
BEFORE STARTING ENGINE
_l_ WARNING:
Be sure to read the fuel
information in the safety rules before you be-
gin. if you do not understand the safety rules,
do not attempt to fuel your unit. Call
1-800-554-6723,
FUELING ENGINE
,_ WARNING:
Remove fuel cap slowly
when refueling.
HELPFUL TIP
I
To obtain the correct oil mix
I
J ratio, pour 3.2 ounces of
I
" 2-cycle synthetic oil into I
one gallon of fresh gas. I
is certified to operate on unleaded
gasoline. Before operation, gasoline must be
mixed with a good quality synthetic 2-cycle
air-cooled engine oil designed to be mixed at a
ratio of 40:1. Poulan/WEED EATER brand
synthetic oil is recommended. Mix gasoline and
oil at a ratio of 40:1, A 40:1 ratio is obtained by
mixing 3.2 ounces (95 mi) of oil with 1 gallon (4
liters) of unleaded gasoline. DO NOT USE
This engine
automotive oil or marine oil. These oils will
cause engine damage. When mixing fuel. follow
instructions printed on container. Once oil is
added to gasoline, shake container momentarily
to assure that the fuel is thoroughly mixed.
Always read and follow the safety rules relating
to fuel before fueling your unit.
IMPORTANT
Experience indicates that alcohol blended
fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads to
separation and formation of acids during stor-
age. Acidic gas can damage the fuel system
of an engine while in storage. To avoid engine
problems, empty the fuel system before stor-
age for 30 days or Ionger. Drain the gas tank.
start the engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel next
season. Never use engine or carburetor
cleaner products in the fuel tank or permanent
damage may occur. See the STORAGE sec-
tion for additional information.
HOW TO STOP YOUR UNIT
• To stop the engine, move the ON/OFF
switch to the OFF position.
• If engine does not stop, move choke lever
to FULL CHOKE position.
8