Poulan Pro PP036 Manual De Instrucciones página 9

ON/OFF Switch
HOW TO START YOUR UNIT
'_WARNING: Avoid any contact with
the muffler. A hot muffler can cause serious
burns.
HELPFUL TIP I
!f your engine still does not I
P start after following these I
instructions, pleas e Carl
1-800-554-5723.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
Position
Primer Bulb
Choke
_Lever
Choke
position
decal
8. Pult starter rope sharply until engine runs,
but no more than 6 pulls. If the engine
doesn't start after 6 puffs (at the HALF
CHOKE position), move the choke lever to
the FULL CHOKE position and press the
primer bulb 6 times. Squeeze and hold the
throttle trigger and pull the starter rope 2
more times. Move the choke lever to the
HALF CHOKE position and pull the starter
rope until the engine runs, but no more than
6 pulis, if the engine doesn't start, repeat
procedure 2 additional times.
NOTE: if engine still doesn't start, it is
probably flooded. Proceed to STARTING A
FLOODED ENGINE.
9. Once the engine starts, aflow it to run 10 se-
conds, then move the choke lever to OFF
CHOKE by aligning lever with position
shown on decal (see illustration below). AF
low the unit to run for 30 more seconds at
OFF CHOKE before releasing the throttle
trigger. NOTE: If engine dies with the
choke lever in the OFF CHOKE position.
move the choke lever to the HALF CHOKE
position and pull the rope until engine runs,
but no more than 6 pulls.
Muffler
1. Set unit on a flat surface.
2. Move ON/OFF switch to the ON position.
3. Slowly press the primer bulb 6 times.
4. Move choke lever to FULL CHOKE by
aligning lever with position shown on de-
cal (see illustration below).
Choke
position
decal
5. Squeeze the throttle trigger fully and hold
through all remaining steps.
6. Pull starter rope handle sharply until en-
gine sounds as if it is trying to start, but do
not pull rope more than 6 times.
7. As soon as engine sounds as if it is trying
to start, move choke lever to HALF
CHOKE by aligning tever with position
shown on decal (see illustration below).
Choke
position
decal
STARTING A WARM ENGINE
1. Move ON/OFF switch to the ON position.
2. Move the choke lever to the HALF
CHOKE position.
3. Squeeze and hold the throttle trigger.
Keep throttle trigger fully squeezed until
the engine runs smoothly.
4. Pull starter rope sharply until engine runs,
but no more than 5 pulls.
5. Allow engine to run 15 seconds, then
movethe choke lever to the OFF CHOKE
position,
NOTE: If engine has not started, pull starter
rope 5 more pulls. If engine still does not run, it
is probably flooded.
STARTING A FLOODED ENGINE
Flooded engines can be started by placing
the choke lever in the OFF CHOKE position;
then, pull the rope to clear the engine of ex-
cess fuel. This could require pulling the starter
handle many times depending on how badly
the unit is flooded.
9