Publicidad
Idiomas disponibles
Idiomas disponibles
2. Using a Phillips screwdriver, remove the two screws.
3. Remove the base grille.
To replace the base grille:
1. Open the beverage center door.
2. Position the base grille so that both tabs align and the base
grille snaps into place. Replace two screws.
Tighten the screws.
Vacation Care
If you choose to turn the beverage center off before you
leave, follow these steps.
1. Remove all beverage contents from the beverage center.
2. Unplug the beverage center.
3. Clean the beverage center. Refer "Cleaning" section.
4. Tape a rubber or wood block to the top of the door to prop
it open far enough for air to get in. This stops odor and
mold from building up.
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
GENERAL OPERATION
Beverage center will not operate
The motor seems to run too much
Manual W11515229B - BC-Ingles.indd 11
Manual W11515229B - BC-Ingles.indd 11
TROUBLESHOOTING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Possible Causes and/or Recommended Solutions
Power supply cord unplugged? Plug into a grounded 3 prong
Is outlet working? Plug in a lamp to see if the outlet is working.
Household fuse blown, or a circuit breaker tripped? Replace the fuse or reset the
circuit. If the problem continues, call an electrician.
Are controls on? Be sure that the beverage center controls are on. Refer "Controls"
section.
Is the temperature outside hotter than normal? Expect the motor to run longer under
warm conditions. At normal temperatures, expect your motor to run about 40 % to
80 % of the time. Under warmer conditions, expect it to run even more of the time.
Is the door opened often? Expect the motor to run longer when this occurs. In order
to conserve energy, try to get everything you need out of the Beverage Center at once,
keep food organized so it is easy to fi nd, and close the door as soon as the food is
removed.
Moving Care
When you are moving your beverage center to a new home,
follow these steps to prepare it for the move.
1. Remove all beverage contents from the beverage center.
2. Unplug the beverage center.
3. Clean, wipe, and dry it thoroughly.
4. Take out all removable parts, wrap them well, and tape
them together so they don't shift and rattle during the
move.
5. Tape the doors shut and tape the power cord to the
beverage center.
When you get to your new home, put everything back and
refer to the "Installation Instructions" received with the
beverage center.
outlet.
11
02/02/21 16:07
02/02/21 16:07
Publicidad
