Publicidad
N x 14
FIG. 7A
7)
Turn unit face down on a clean protected surface; measure from top left to bottom right (
and from top right to bottom left (
line (
) Is longer, tap bottom of side at ( ), until measurements are equal. If line (
/
tap bottom of side at ( ) until measurements are equal. See FIGURE 7A.
Place bottom edge of backs flush with bottom edge of tower assemblies and centered side to side.
Attach Backs (J) to the tower assemblies using #6x5/8" Philtruss Screws (N) in all the predrilled
holes in the backs except for the lowest outside hole. On these holes, attach a Mending Plate (O)
using the #6x5/8" Philtruss Screws (N). See FIGURE 7B.
Attach two Pads (P) to the bottom of the Side Panels and Vertical Dividers.
R x 4
Sa x 4
FIG. 8A
Install the Adjustable Shelf (T) at the desired location using the Shelf Brackets (R). See FIGURE 8A.
8)
Attach the shelf to the shelf brackets by screwing a #6 x 1/2" Undercut Screw (Sa) through the
bottom of the shelf bracket into the shelf. See FIGURE 8B.
9)
Secure hutch to desk using #6x5/8" Philtruss Screws (N) in the other holes of the mending plates.
PAGE 6 – 637Wa (Rev. 8/07)
O x 2
P x 8
FIG. 7B
). The measurements should be equal. See FIGURE 7A. If
/
N
N
N
N
N
J
N
R
T
FIG. 8B
J
N
637W
Hutch
O
636W
Desk
N
)
/
) Is longer,
/
Sa
Publicidad
