Tripp-Lite SRXCOOL7KRM Manual Del Propietário página 2

Introduction
The self-contained Rack-Mount Air Conditioning Unit provides 7,000 BTU (up to 2 kWh) of supplemental cooling capacity. Designed for IT
environments, it's ideal for cooling overheated rack enclosures and network closets without access to facility air conditioning. It also filters and
dehumidifies air to improve operating conditions and equipment reliability. Condensate is re-evaporated for drip-free operation, so you won't
waste time emptying water collection tanks. The self-contained design does not require any plumbing or special circuits, so setup is quick and
easy. Eco-friendly R410A refrigerant meets environmental standards.
Recommended Installation Position
Vent installed
facing upward
Cooling an overheated rack enclosure.
Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during the installation, operation
and storage of this product. Failure to heed these warnings may affect your warranty.
Location Warnings
• The individual user should determine prior to use whether this device is suitable, adequate or safe for the use intended. Since individual
applications are subject to great variation, the manufacturer makes no representation or warranty as to the suitability or fitness of this device
for any specific application.
• Install the unit indoors, away from extreme temperatures or humidity, direct sunlight, dust and conductive contaminants
• For best results, the ambient room temperature should be between 32°F and 104°F (0°C and 40°C).
Installation and Connection Warnings
CAUTION: Installation should be performed by qualified professional electrical service personnel only.
• Install in accordance with Local Electrical Code standards. Be sure to use the proper overcurrent protection for the installation in accordance
with the equipment rating.
• Overcurrent protection shall be provided in the end-use application, installed in accordance with local and electrical wiring regulations.
• The power source supplying the unit must be rated in accordance with the unit's nameplate.
• An appropriate and readily accessible two-pole disconnect device must be incorporated in the fixed wiring.
• Be sure to use a protective earth ground wire in the installation. Failure to do so may create a serious electric shock hazard.
Maintenance should be performed by trained service personnel only.
• Turn the unit off using the ON/OFF button and disconnect it from the AC power before performing maintenance.
• Before connecting the unit to a dedicated drainage system, turn it off and disconnect it from power before performing maintenance.
• Always use the local two pole electrical disconnect device before performing maintenance and servicing. Failure to do so may cause a serious
electric shock hazard.
• Do not use thinners, alcohol, detergents or abrasive brushes to clean the unit's cabinet. These items may damage the cabinet.
• Do not pour water over the unit. This may cause an electric shock and damage the unit.
• Do not operate the unit without the air filter. This may cause dust accumulation that may damage the unit.
• Do not attempt to operate the unit in a room with inadequate air circulation.
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life
support equipment or to significantly affect its safety or effectiveness is not recommended.
2