Publicidad
Idiomas disponibles
Idiomas disponibles
SMART ROUND THERMOSTAT COVER PLATE
CAUTION
Electrical Hazard.
Can cause electrical shock or equipment damage.
Disconnect power before beginning installation.
Mount Wall Cover
Mount Wall Cover Directly to Wall (See Fig. 2)
1. Pull the wires through the wire hole on the wall cover.
2. Position the wall cover on the wall with the arrow pointing up. Check that the wall cover is leveled (for
appearance only).
3. Use a pencil to mark the mounting holes.
4. Remove the wall cover from the wall and proceed as follow:
• For drywall: Drill two 3/16-in. holes in the wall as marked. Tap the wall anchors (provided with the
thermostat) into the holes, until the anchor collar touches the wall.
• For harder surface such as plaster: Drill two 7/32-in. holes in the wall as marked. Tap the wall anchors
(provided with the thermostat) into the holes, until the anchor collar touches the wall.
5. Position the wall plate on the wall cover using the 4 mounting posts and snap them together.
6. Pull the wires through the wire hole on the wall cover / wall plate assembly. Position the assembly on the
wall anchors.
7. Insert the mounting screws (provided with the thermostat) into the wall anchors. Check leveling, if desired,
and tighten the mounting screws.
WALL
OPENING
WIRE
WALL ANCHORS (2)
(PROVIDED WITH
THERMOSTAT)
Fig. 2. Mount wall cover, wall plate and thermostat directly to wall.
33-00069EFS—04
WALL COVER
MOUNTING HOLES (2)
WIRE HOLE
L
C
AUX
W
Y
2
O/B
W
Y
Universal
U
R
1
Hum
Dehum
U
R
2
C
Vent
1 Wire
R
2 Wire
R & RC
2
MOUNTING POSTS (4)
WALL PLATE
MOUNTING HOLES (2)
WIRE HOLE
MOUNTING SCREWS (2)
(PROVIDED WITH
THERMOSTAT)
K
G
a
THERMOSTAT
M35407
Publicidad
