Craftsman INCREDI-PULL 316.292620 Manual Del Operador página 16

CAUSE
Empty fuel tank
Primer bulb wasn't pressed enough
Engine is flooded
Old fuel
Fouled spark plug
Plugged spark arrestor
The outside temperature is below 40 ° F
The outside temperature is above 90 ° F
CAUSE
Air filter is plugged
Old fuel
Improper carburetor adjustment
CAUSE
Old fuel
Improper carburetor adjustment
Dirty air filter
Plugged spark arrestor
CAUSE
Old fuel
Improper carburetor adjustment
Fouled spark plug
Plugged spark arrestor
Cultivator tines bound with debris
ACTION
Fill fuel tank with new fuel
Press primer bulb fully and slowly 10 times
Squeeze the trigger and pull the starter rope
Drain gas tank and add fresh fuel
Replace the spark plug
Clean or replace spark arrestor
Pull the starter rope up to 10-15 times
Squeeze the throttle control and pull the starter rope
ACTION
Replace or clean the air filter
Drain gas tank and add fresh fuel
Adjust according to the Carburetor Adjustments section
ACTION
Drain gas tank and add fresh fuel
Take to a Sears Parts & Repair center or other qualified
service dealer for an adjustment
Clean or replace the air filter
Clean or replace spark arrestor
ACTION
Drain gas tank and add fresh fuel
Take to a Sears Parts & Repair center or other qualified
service dealer for an adjustment
Replace the spark plug
Clean or replace spark arrestor
Stop the unit, switch the On/Off Stop Control to
STOP, clean and remove any debris binding the tines
CAUSE
Spark plug gap is too small/close
ACTION
Adjust gap to 0.020 inch (0.50 mm)
NOTE: For repairs beyond the minor adjustments listed above, contact your nearest Sears Parts &
Repair center (1-800-4-MY-HOME ®) or other qualified service dealer for an adjustment.
16