GreenWorks GD60BPB Manual Del Operario página 6

4 OPERATION
WARNING
Make sure the blower tube is in position before
operation.
4.1 INSTALL THE BATTERY PACK
Figure 11.
WARNING
• If the battery pack or charger is damaged, replace
them directly.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, understand, and follow the instructions in
the battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery slot.
2. Push the battery pack into the battery slot until the
battery pack locks into place.
3. When you hear a click, the battery pack is installed.
4.2 REMOVE THE BATTERY PACK
Figure 11.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4.3 START THE MACHINE
Figure 1.
1. Pull the trigger to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.
4.4 STOP THE MACHINE
Figure 1.
1. Release the trigger to stop the machine.
NOTE
Wait until the engine stops after you stop the machine.
4.5 CRUISE CONTROL LEVER
Figure 1.
1. Pull the cruise control lever clockwise to increase
the speed. This will lock the speed at the desired
setting.
2. Push the cruise control lever counter clockwise to
decrease the speed.
English
If you decrease the speed all the way, the unit will stop
and it is necessary to start the machine again.
4.6 TURBO BUTTON
Figure 1.
1. Push the turbo button, the machine is at the highest
speed.
2. Release the turbo button, the machine is at the
normal speed.
4.7 OPERATE THE MACHINE
Figure 16.
1. Hold the machine tightly with one hand.
2. Blow from side to side with the nozzle above the
ground.
3. Move forward slowly.
Keep the unwanted materials in front of you
Move heavier materials at a high speed while lighter
materials at a low speed.
4.8 OPERATION TIPS
• Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
• Use rakes and brooms to clear the unwanted
material before you blow.
• Make the surfaces wet before you clear the
unwanted material in dusty conditions.
• Look out for children, pets, open windows, and
cleaned cars during operation.
• Clean the machine.
• Discard the unwanted material when you complete
work.
5 MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
5
NOTE
NOTE
NOTE
CAUTION
CAUTION
EN