Delta 23-206 Manual De Instrucciones página 10

ATTACH SPARK SHIELD AND EYE
SHIELD
1.
Tighten the Eye Shield/Spark Shield Assembly
grinder with M5 x 8 Spring Pad Flat Pad Combination
Parts using a Philips screwdriver.
HP1
See Figure 1.
NOTE: Adjust eye shield to appropriate distance from tool rest
avoiding interference when operation.
ATTACH TOOL REST
1.
Remove the knob
B
the carriage bolt on the lower portion of wheel guard.
Using the carriage bolt, lock washer, flat washer and
knob, attach the tool rest supports
the wheel guard as shown.
2.
Attach beveled tool rest
using one M6 x 17 Handle
and Flat Washer D6
HP3
3.
Adjust the position of the tool rest support so that the
tool rest is approximately 1/8 inch from the grinding
wheel .
A
4.
Repeat above steps for second tool rest.
See Figure 2.
ATTACH COOLANT TRAY
1.
Attach Coolant Tray
the bracket located on the front of the grinder.
See Figure 2.
ASSEMBLY
, lock washer, and flat washer from
to the inside of
PC5
to the tool rest support
PC4
, Spring Washer D6
HP2
.
to the grinder by sliding it onto
PC7
to
PC2
PC2
A
,
HP4
PC5
PC7
10
HP1
Figure 1
PC4
HP3
HP4
B
Figure 2
HP2