EXTENSION CORDS
When using a power tool at a considerable distance from a power source, be sure to use an extension cord that has the capacity to
handle the current the tool will draw. An undersized cord will cause a drop in line voltage, resulting in overheating and loss of power.
Use the chart to determine the minimum wire size required in an extension cord. ONLY round jacketed cords listed by Underwriter's
Laboratories (UL) should be used.
NOTE: Before using any extension cord, inspect it for loose or
exposed wires and cut or worn insulation.
KEEP the extension cord clear of the work
area. Position the cord so that it will not get caught on lumber,
tools or other obstructions while you are working with a power
tool. Failure to do so can result in serious personal injury. Check
extension cords before each use. If damaged replace
immediately. NEVER use tool with a damaged cord, since
touching the damaged area could cause electrical shock
resulting in serious injury.
Compare all parts to the list below and check that all parts are present and in good condition. Report any missing or damaged parts
to your distributor or dealer. Prior to tool assembly and use, read this manual thoroughly to familiarize yourself with proper assembly,
maintenance and safety procedures.
PC1
PC5
PACKAGE CONTENTS
PC1
23-206 6 inch Grinder or 23-207 8 inch Grinder
Eye Shield/Spark Shield Assembly (2)
PC2
Flat Tool Rest (1)
PC3
Beveled Tool Rest (1)
PC4
Tool Rest Supports (2)
PC5
PC6
Wheel Dressing Tool (1)
POWER CONNECTIONS
UNPACKING
PC6
Coolant Tray (1)
PC7
8
** Ampere rating (on total data label)
5A and less
Cord Length
25'
50'
** Used on 12 gauge - 20 amp circuit
NOTE: AWG = American Wire Gauge
PC2
PC7
Wire Size
16 AWG
16 AWG
PC3
PC4