AROHA Safety Pro Manual página 4

EN
Aroha Safety Pro CO Detector user manual
Please read the manual carefully to ensure safe, proper use and store it in a
safe place for future reference. Scan the QR-code or visit
for the step-by-step instructions with video to safely install your detector and
consult the FAQ.
A. Activate/Deactivate the detector
The device is deactivated by default before leaving our factory.
Before the detector can be used, it must be activated.
Power on: Set the switch on the back of the detector to "ON" using the supplied stick. The
detector beeps and the LCD screen lights up blue, after which the value increases from
000 to 999. When the screen is at 0 ppm, the detector is activated.
Power off: Set the switch on the back of the detector to "OFF" using the supplied stick.
Why is the value 0 ppm? The default value is 0 ppm, because the natural carbon monoxide (CO)
in the air is approximately 0.2 ppm, which is rounded to 0 ppm. The display always shows the real-
time value of the amount of CO, but in a "normal" situation this is 0 ppm.
CAUTION
The installation instructions must be followed strictly to avoid unsafe conditions.
Do not paint your detector.
The battery cannot be replaced; do not try to replace the battery as this will render the detector
unuseable and can cause a fire due to the high-capacity lithium battery.
CO detectors are not smoke detectors. This CO detector is not a substitute for installing and
maintaining an appropriate number of smoke detectors in your home.
03
www.aroha.nl/manual
Instructions, video & FAQ