Husqvarna LF 60i LAT Manual De Usuario página 14

1. Hold the handle and steer the product. Do not push
the product forward. Let the drive system of the
product operate the product forward.
CAUTION:
down. Too much pressure can cause
unsatisfactory result.
CAUTION:
inlet.
2. To change direction, turn the product around.
To adjust the speed
When you start the product, the product operates at
standard speed.
1. Start the product, refer to
page 13 .
2. Push the slow speed control button. The indicator for
low speed comes on.
3. To operate the product at standard speed, push the
slow speed control button again. The indicator for
low speed goes off.
Note:
You can adjust the speed with the slow speed
control button when the product moves.
To set the product in operation position
WARNING:
when you set the product in operation
position. Use protective gloves.
1. Loosen the handle knobs (A).
2. Lift the handle (B).
3. Tighten the handle knobs (A).
14
Do not push the product
Do not block the air
To start the product on
There is a risk of pinching
A
B
To fold the low vibration handle up and down
You can use the low vibration handle to decrease the
vibration level.
• Pull the low vibration handle to release it from the
clamps.
• Fold down the low vibration handle and push it into
the clamps to lock it.
To set the product in transport position
WARNING:
when you set the product in transport
position. Use protective gloves.
There is a risk of pinching
1948 - 003 - 13.02.2024