Husqvarna LF 60i LAT Manual De Usuario página 17

To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
To install and remove the batteries
1. Stop the product. Refer to
page 13 .
2. Lift up the battery covers (A).
3. Install the batteries. The batteries are correctly
installed when you hear a click.
WARNING:
Husqvarna BLi batteries.
CAUTION:
install the batteries. If the batteries
cannot easily go into the battery
compartments, the batteries are not
installed correctly.
1948 - 003 - 13.02.2024
To stop the product on
A
Only use original
Do not use force to
4. Make sure that the battery covers are fully closed
to prevent that moist and dirt enter the battery
compartments.
5. Remove the batteries in the opposite sequence.
To do a check of the belt
WARNING:
without the belt cover installed.
1. Remove the batteries from the product. Refer to
install and remove the batteries on page 17 .
2. Loosen the 4 bolts and remove the belt cover.
3. Examine the belt for damages and wear. Replace
the belt if it is necessary.
4. Examine the tension of the belt. The correct tension
is 60–80 N.
Do not operate the product
To
17