Troy-Bilt 030247 Manual Del Operario página 4

Section 1: Safety Rules
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment to cool before touching.
Keep at least 5 ft. (152 cm) clearance on all sides of generator
including overhead.
Code of Federal Regulation (CFR) Tide 36 Parks, Forests, and
Public Property reqore equipment powered by an internal
combustion engine to have a spark arrester_ maintained in
effective working order; complying to USDA Forest service
standard 5100-IC or later revision. In the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws,
WARNING
WHEN ADJUSTING OR MAKING REPAiRSTOYOUR
GENERATOR
Disconnect the spark pJug wire from the spark plugand place
the wire where itcannot contactspark plug.
WNENTESTING
FOR
ENGINE
SPARK
Use approved spark plugtester:
DO NOT check for spark with spark plug removed,
CAUTION
DO NOT tamper with governed speed. Generator supplies
correct rated frequency and voltage when running at governed
speed.
DO NOT modify generator in any way.
See "Don't Overload Generator".
Start generator and let engine stabilize before connecting
electrical
loads,
Connect electrical loads in OFF position, then turn ON for
operation.
Turn electrical loads OFF and disconnect from generator
before stopping generator.
Use generator only for intended uses.
If you have questions about intended use, ask dealer or call
[ -888-6 [ [ -6708.
Operate generator only on level surfaces.
DO NOT expose generator to excessive moisture, dust, dirt,
or" corrosive vapors.
DO NOT insert any objects through cooling slots,
If connected devices overheat_ turn them off and disconnect
them from generator:
Shut off generator if:
-electrical
output is lost;
-equipment sparks, smokes, or emits flames;
-unit vibrates excessively.