Publicidad
Idiomas disponibles
Idiomas disponibles
Theoperation ofany tillercanresult inforeign o bjects thrown i ntotheeyes,
which c anresult i nsevere e yedamage. Always w ear s afety g lasses oreye
shields before s tarting y our t iller a ndwhile tilling. W erecommend
standard
safety g lasses orawide vision safety m ask worn over s pectacles.
HOW
TO USE YOUR
TILLER
Know how to operate all controls before
adding fuel and oil or attempting to start
engine.
STOPPING
TINES
• Release tine control to stop movement.
ENGINE
• Move throttle control to "STOP" position.
NOTE: Never use choke to stop engine.
Tine Control
"Off" (UP) Position
WHEELS
Adjust wheels by removing the hairpin clip
and clevis pin. Change wheel position.
Replace the hairpin clip and clevis pin.
• For normal tilling, set wheels at the
second or third hole from the top.
Hairpin Clip and
;levis Pin
Stake
Wheel
Spring
Depth
Stake
Choke
Control
Control
TINE OPERATION
• Squeeze tine control to handle.
TiLLiNG
The speed and depth of tilling is regulated
by the position of the depth stake and
wheel height.
The depth stake should always be below
the wheels for digging.
It serves as a
brake to slow the tiller's forward motion to
enable the tines to penetrate the ground.
Also, the more the depth stake is lowered
into the ground the deeper the tines will
dig.
DEPTH
STAKE
Adjust depth stake by removing the hairpin
clip and clevis pin. Change depth stake
to desired position. Replace the clevis pin
and hairpin clip.
• For normal tilling, set depth stake at the
second or third hole from the top.
TO TRANSPORT
_I_CAUTION: Before lifting or transporting,
allow tiller engine and muffler to coot. Dis-
connect spark plug wire. Drain gasoline
from fuel tank.
AROUND THE YARD
1. Tip depth stake forward until it is held
by the stake spring.
2. Push tiller handles down, raising tines
off the ground.
3. Push or pull tiller to desired location.
AROUND TOWN
1. Disconnect spark plug wire.
2. Drain fuel tank.
3. Transport in upright position to prevent
oil leakage.
BEFORE
STARTING
ENGINE
IMPORTANT:
Be very careful not to allow
dirt to enter the engine when checking or
adding oil or fuel. Use clean oil and fuel
and store in approved, clean, covered
containers,
use clean fill funnels.
FILL ENGINE WITH OIL
1. Remove hangtag from engine.
2. With engine bevel, remove engine oil
filler plug.
3. Fill engine with oil to point of overflow-
ing. For approximate capacity see
"PRODUCT SPECIFICATIONS"
on
page 4 of this manual. All oil must
meet A.RI. Service Classification
SG-
SL
Publicidad
