Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Slide adjustable nozzle forward to low pressure mode.
Detergent
cannot be applied with nozzle in high
pressure position.
5.
Make sure garden hose is connected to water
inlet.
Check that high pressure hose is connected to spray
gun and pump. Start engine.
6.
Apply detergent
to a dry surface, starting at lower
portion
of area to be washed
and work
upward, using
long, even, overlapping
strokes.
7.
Allow detergent
to "soak in" for 3-5 minutes
before
washing and rinsing. Reapply as needed
to prevent
surface from drying. DO NOT allow detergent
to dry
on (prevents
streaking).
IMPORTANT:You
must flush the chemical
injection
system
after each use by placing the filter into a bucket
of
clean water, then run the pressure
washer
in low pressure
for 1-2 minutes.
Pressure
Washer
Rinsing
For Rinsing:
I.
Slide nozzle backward to high pressure, squeeze trigger
and wait for detergent
to clear.
NOTE:
You can also stop detergent from flowing by simply
removing chemical injection hose from bottle.
.
Keep spray gun a safe distance
from the area you plan
to spray.
WARNING
Keep spray nozzle
between
8 to 24 inches
away from cleaning
surface.
Operate
this unit on a stable surface.
Be extremely
careful if you must use the pressure washer from
a ladder, scaffolding or any other relatively
unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
3.
Apply a high pressure
spray to a small area, then check
surface for damage. If no damage is found, it is okay to
continue
cleaning.
4.
Start at the top of the area to be rinsed, working
down
with same overlapping
strokes
as you used for washing
and applying detergent.
Automatic
Cool Down
System
(Thermal
Relief)
If you run the engine on your pressure washer for
3-5 minutes without
pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°F.The system engages to cool the pump by
discharging
the warm
water
onto
the ground.
Publicidad
