Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARING
THE
UNIT
FOR STORAGE
Water
should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the
pressure washer for more than 30 days, follow this
procedure:
I.
Flush chemical injection hose by placing filter into a
pail of clean water while running pressure washer in
low pressure mode (adjustable nozzle in forward
position). Flush for one to two minutes.
2.
Shut off engine and let it cool, then remove high
pressure and garden hoses. Disconnect
spark plug wire
from spark plug.
3.
Empty pump of all pumped liquids by pulling recoil
handle about 6 times.This
should remove most liquid
in pump.
4.
Use PumpSaver to prevent corrosion
build up and
freezing of pump.
5.
Store unit in a clean, dry area.
Protecting
the
Pump
To protect
the pump from damage caused
by mineral
deposits
or freezing, use PumpSaver
to treat
pump.This
prevents
freeze
damage
and lubricates
pistons
and seals.
NOTE:
PumpSaver
is available as an optional
accessory.
It
is not included
with the pressure
washer. Contact
the
nearest authorized
service center
to purchase
PumpSaver.
CAUTION
* Failure to do so will permanently damage your pump and
render your unit inoperable.
* Freeze damage is not covered under warranty.
CAUTION
Always wear eye protection when using PumpSaver.
To use PumpSaver, make sure the pressure
washer
is
turned
off and disconnected
from supply water. Read and
follow all instructions
and warnings
given on the
PumpSaver
container.
NOTE:
PumpSaver
will drip from pump after treatment
and will stain wood
and concrete.
NOTE:
if PumpSaver
is not available, draw RV antifreeze
(non-alcohol)
into the pump by pouring
the solution
into a
3=foot section of garden
hose connected
to inlet adapter
and pulling recoil handle twice.
STORING
THE
ENGINE
See the engine owner's
manual for instructions
on how to
properly
prepare
the engine for storage.
Publicidad
