Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THE MOTOR VENTS AND FILTER
It's important that the motor vents on the machine hood are kept free of any buildup. Failure to keep these vents clean
could cause the Freestyle to overheat. Remove the vacuum hose from the Freestyle base and vacuum the motor vents
after each use.
CLEANING THE INTERIOR OF THE FREESTYLE
1. Check the vacuum hose for clogs.
a. Unplug both ends of the vacuum hose and check for
any buildup of HOST or dirt.
b. If buildup exists, plug straight end of the vacuum hose
into the vacuum connection.
c. Turn the vacuum motor on and loosen buildup from the
vacuum hose elbow.
2. Check the vacuum shoe between the cleaning brushes
on the underside of the Freestyle for buildup. Remove any
material clogging the shoe. Wipe out the underside of the
Freestyle with a cloth or brush, or use a vacuum.
TROUBLESHOOTING
PROBLEM
Loss of suction power.
Freestyle does not run.
Filter light is on.
THE CLEANING SYSTEM that makes A DIFFERENCE
POSSIBLE CAUSE
Filters are extremely dirty.
Velcro skirt is too low.
Freestyle is not plugged into wall plug.
Power cord is not properly secured to the
pigtail twist lock.
Blown a fuse.
Not turning the motor switch on.
Filters are extremely dirty.
Bagless hopper is full.
Clogged up.
hostdry.com | 800-558-9439
3. Check under the separator assembly and in the vacuum
cone for buildup. Buildup will occur more frequently if
you have not emptied the bagless hopper as o en as
needed.
a. With bagless hopper in place, unlatch the top of the
machine, swing the filter housing to the side and
remove the filters.
b. Li out the separator assembly and wipe the underside
of the separator assembly and the inside of the
vacuum cone with a clean, dry cloth. If there is a thick
accumulation on the cone, use a damp cloth to loosen
the soil. The loosened soil will drop into the bagless
hopper.
c. Replace the separator assembly and push down firmly
until it seals tightly.
POSSIBLE SOLUTION
Clean and/or replace filters.
Adjust the Velcro skirt height. The lower edge of
the Velcro skirt should just brush the floor. Starting
in the middle of the brush guard/end cover plate,
line up the slits on the Velcro skirt with the corners
of the Freestyle.
Plug Freestyle cord into wall plug.
Twist the pigtail lock cord on the back of the
machine.
Fix fuse.
Turn the motor switch on. If the switches are on
and it still doesn't run, it should be returned to the
manufacturer or authorized repair center. Contact
your HOST Distributor.
Clean and/or replace filters.
Empty bagless hopper.
Check to see if hose is clogged, the shoe is clogged
or the vacuum cone has buildup.
11
Publicidad
