Publicidad
Idiomas disponibles
Idiomas disponibles
6
Apply HOST Dry Extraction
Cleaner to the floor,
either by hand or with the
Applicator. If applying HOST
cleaner by hand use about
one handful size for each
square yard (3' x 3') (1.6). Do
not apply more than 100 to
200 square feet at a time or
the HOST cleaner could dry
out and not clean as well.
For the HOST Applicator,
place HOST cleaner into
the applicator and choose
light, medium, or heavy
setting. Then guide the
HOST Applicator over the
area to be cleaned. As it
rolls, it dispenses the chosen
amount of micro-sponges
(1.7).
7
Once you applied the HOST
Dry Extraction Cleaner to the
floor, make sure the white
vacuum switch is OFF and
the brush switch is turned
ON. Make three passes over
the area. Use push-pull
strokes just like when you
vacuum (1.8). This brushing
action distributes the HOST
micro-sponges and brings
them in contact with the
dirty surfaces of what you
are cleaning.
8
Turn both machine brushes
and vacuum switches ON.
Vacuum the area you have
just finished brushing in
2 directions: north/south
and east/west. Continue to
vacuum in 2 directions until
all visible HOST is recovered.
The Freestyle vacuums
best if HOST is a bit damp.
Repeat if necessary.
THE CLEANING SYSTEM that makes A DIFFERENCE
(1.6)
9
(1.7)
1st Pass
2nd Pass
3rd Pass
(1.8)
hostdry.com | 800-558-9439
If Flooring is Still Dirty
If flooring is still dirty, reapply HOST
and brush again.
Empty the bagless hopper
o en to avoid clogging filters.
Place one hand against the
side of the Freestyle and pull
out the hopper with the other
hand. Empty the bagless
hopper, a er emptying,
push the hopper firmly back
into the hopper guides until
it stops. The hopper must
be completely closed to
maintain full vacuum power
and to prevent premature
filter clogging. Overloading
of the hopper will cause
rapid filter clogging as well
as HOST Dry Extraction
Cleaner to accumulate on
the inner cone assembly.
Pull Handle
Out
Li and
turn handle
release knob
1/4 turn
When Cleaning
Stairs with
the Freestyle
To clean the stairs with
the Freestyle, handle
will need to be removed from the machine. Pull
and turn the lock release pin on the vacuum pod
1⁄ 4 turn so it is in the release position. With two
hands, grasp the vacuum pod and lower it onto
the handle bracket so the lower pins fit through
the holes in the handle bracket. The lock release
pin will drop in place. Turn lock release pin 1⁄ 4 turn
until it locks in position. Insert the vacuum hose
into the machine base. Plug the black vacuum
pod power cord into the vacuum power cord
receptacle located on the top of the machine base.
Unscrew handle locking
sha completely, lower
handle parallel to floor
and slide handle out
7
Publicidad
