Host Liberator Manual De Instrucciones página 6

USING THE LIBERATOR
Note: Standard (white) and firm (zebra) brushes must be broken in before using for the
first time. To break in brushes, run the Liberator on hard surface for three minutes.
1
Plug the Liberator power
cord into electrical outlet.
Do not use an extension
cord.
2
When removing the
Liberator from the caddy
lock Liberator handle in
position by pointing red
arrowhead down (1.1).
Note that there are 2
handle locks, one on
each side of machine.
Next unlock locking bolts
on front of caddy (1.2).
Locate the switch control
panel on the back of
the Liberator (1.3). Turn
ON machine brushes by
pressing the black switch
and drive the Liberator o
the caddy. Turn power OFF
and move the caddy out of
the way.
Before Applying HOST Dry Extraction Cleaner
Before applying HOST Dry Extraction Cleaner to the floor, place bucket on its side for 10 minutes. This will
help to distribute the liquid ingredients evenly throughout the cleaner. Be sure to wipe o the edge of bucket
before replacing the lid. This will prevent leaking.
6
Green/Unlocked
Red/Locked
Handle Locking Knob (1.1)
Locking
Bolts (1.2)
Filter light
Filter Light/ Filtro de luz
HOSTDRY.com
800-558-9439
Vacuum/Vacío Brushes/Cepillos
White vacuum Black brush
switch switch
(1.3)
3
Turn the white vacuum
switch and black brush
switch ON. Vacuum and
pile li carpet thoroughly
before applying HOST Dry
Extraction Cleaner. Vacuum
the area in 2 directions:
north/south and east/west
(1.4). The more vacuuming
the better to remove as
much dry dirt as possible.
In hallways and open areas,
vacuum lawnmower style
in 2 directions: north/south
and east/west (1.5).
4
Apply HOST Dry Extraction
Cleaner to the floor,
either by hand or with the
Applicator. If applying HOST
cleaner by hand use about
one handful size for each
square yard (3' x 3') (1.6). Do
not apply more than 100 to
200 square feet at a time or
the HOST cleaner could dry
out and not clean as well.
For the HOST Applicator,
place HOST cleaner into
the applicator and choose
light, medium, or heavy
setting. Then guide the
HOST Applicator over the
area to be cleaned. As it
rolls, it dispenses the chosen
amount of micro-sponges
(1.7).
(1.4)
(1.5)
(1.6)
(1.7)