Publicidad
ESPAÑOL
be installed on a normal or vaulted ceiling with a downrod. The hanging length can
be extended by using a longer down rod. Assembly according to the type of ceiling:
Wooden ceiling. Fig. 3
Concrete ceiling. Fig. 4
To assemble this ceiling fan, follow the steps below (Fig. 3-9):
1. Follow the instructions in the installation section to install the mounting bracket
according to ceiling type.
2. Then take the main body of the fan and attach it to the mounting bracket as shown
in Figure 6.
3. Take the receiver and make the electrical connections by means of quick connectors.
Once connections are made, insert the receiver inside the upper part of the fan main
body. Follow the wiring instructions shown in Figure 5.
4. Unhook the fan from the hook and screw the mounting bracket to the main body.
Screw the two screws into the mounting bracket without over-tightening them. Then,
attach the fan main body to the previously fixed screws and tighten the latter. Fig. 6.
5. To install the blades, use the screws and washers supplied in the installation kit.
Install the blade making sure the pointed end faces downwards. Align the blade with
the holes on the underside of the main body and insert the screws. Repeat this step
until all blades are installed. Fig. 7
6. Connect the LED board to the two electrical connectors and fix it to the LED-board
bracket using the magnets provided on the LED board. Fig. 8-9
7. Finally, take the lamp and screw it onto the LED board bracket as shown in Figure
10.
Warning
Self-tapping screws are only suitable for wooden ceilings. In case of installing the
ceiling fan to concrete ceilings or joists, use a drill for making the holes and plugs or
expansion screws (not included).
4. OPERATION
Remote control. Fig. 11
1. Power button
2. Speed control
3. Winter function
4. Summer function
5. Natural Breeze
6. Natural Breeze shut-off
21
VENTILADOR DE TECHO EVVO V550/V551 WOOD WIFI
Publicidad
