Control Panel Operation - Walter Surface Technologies ICECUT100 Manual De Instrucciones


Only use approved cutting fluid. Walter ICECUT cutting fluid has been specially formulated to maximise the cutters
performance. It is available in 5 litres (53-C 056) and 20 litres (53-C 057).

7) CONTROL PANEL OPERATION

1) Power
When the drill is connected to
the power supply, the RED LED
will indicate power to the drill.
4) Motor ON
Press the GREEN Switch to turn
the motor on. Proceed with
cutting- following all safety
guidelines...
2) Magnet ON
To turn the magnet ON or OFF,
depress the large button on the
control panel. A GREEN LED will
indicate the magnet is ON.
5) Annular cutting
See below for detailed description of
the control visual indicator
9
3) Motor switch
When the magnet has power
the GREEN switch will light up to
indicate motor start.
6) Motor OFF
To stop the motor press the RED
switch. The motor will stop and
the magnet will remain on. The
GREEN switch will turn on.