Craftsman 917.28934 Manual Del Operador página 22

TO LEVEL MOWER
Make sure tires are properly inflated to the
PSI shown on tires. If tires are over or under
inflated, it may affect the appearance ofyour
lawn and lead you to think the mower _s not
adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT
t. With all tires properly inflated and if your
lawn appears unevenly cut, determine
which side of mower is cutting lower,.
2. With a 3/4" or adjustable wrench, turn lift
link adjustment nut (A) to the Ieft to lower
LH side of mower, or, to the right to raise
LH side of mower,
NOTE: Each full turn of adjustment nut will
change mower height about 3/t6"
Turn nut rig Turn nut left
to raise mower lower mower
3. Test your adjustment by mowing some
uncut grass and visually checking the
appearance. Readjust, if necessary, until
you are satisfied with the results.
PRECISION SIDE-TO.SIDE ADJUSTMENT
1.. With alltires properly inflated, parktractor
on level ground or driveway,
_, CAUTION: Blades are sharp. Protect
your hands with gloves and!or wrap blade
with heavy cloth.
2. Raise mower to its highest position.
3_ At both sides of mower, position blade at
side and measure the distance (A) from
bottom edge of blade to the ground. The
distance should be the same on both
sides.
4. if adjustment is necessary, see step 2 in
Visual Adjustment instructions above.
5. Recheck measurements, adjustifneces-
sary until both sides are equal_
A _ _ ............ JR
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-
to-side.
To obtain the best cutting results, the mower
blades should be adjusted so the front tip is
I/8" to 1t2" lower than the rear tip when the
ower is in its highest position
CAUTION: Blades are sharp.. Protect
your hands with gloves andlor wrap blade
with heavy cloth.
, Raise mower to highest position
, Position any blade so the tip is pointing
straight forward Measure distance (B)
to the ground at front and rear tip of the
blade.
• If fronttip ofblade is not 118" to tt2" lower
than the rear tip, go to the front of tractor.
• With an 11t16" or adjustable wrench,
loosen jam nut A several turns to clear
adjustment nut B.
With a 3/4" or adjustable wrench, turn
front link adjustment nut (B) clockwise
(tighten) to raise the front of mower, or,
counterclockwise (loosen) to lower the
front mower..
Tighten adjust nut
B to raise mower
Loosen adjust
nut B to lower
mower
Loosen jam nut A first
NOTE: Each full turn of the adjustment nut
will change mower height about 1t8'L
• Recheck measurements, adjust if neces-
sary until front tip of blade is 1t8" to 1f2"
lower than the rear tip_
° Hold adjustment nut in position with wrench
and tighten jam nut securely against ad-
justment nut.
22