Kenmore 795.7943 Serie Manual De Uso Y Cuidado página 16

REFRIGERATOR INSTALLATION
9. Using a 13 / 32 '' socket wrench with a 2-Inch extension
and a screwdriver, loosen the two bolts and one screw,
and remove the bottom hinge from the right side of
the housing.
10. Remove the decorative caps on the bottom of the
refrigerator housing. You will need these holes for
the bottom hinge.
11. Move the bottom hinge to the left side of the housing,
keeping the same orientation, and reattach with the
on the exterior side of the hinge. Move the decorative
bolt to thehole on the lower right side of the housing.
Leveler
NOTE: The leveler is only present on some models.
WARNING :If you reinstall or replace the doors, move
the leveler to the opposite side.
12 . Turn the refrigerator door upside down on a non
scratching surface. Loosen the three screws to remove
the hinge pin bracket, the hinge pin insert and the
door closer.
Door
Closer/
Stop
13 .
15. Remove the outer lower decorative screw from the
screw must be placed
NOTE:
in the same orientation with its hexagonal end facing
upward
Hinge
Pin Bracket
Hinge Pin
Insert
16
Reverse the Door Closer/Stop by flipping it over. Place
the hinge pin bracket, and the hinge pin insert keeping
the same orientation on the opposite door side, then
place the door clooser on top, and tighten the 3 philliphs
screws.
Hinge
Pin Bracket
Hinge Pin
Insert
remove the cover over the screw holes on the left side of
refrigerator housing.
housing at the area between the freezer and refrigerator
doors. (You will need this hole for the middle hinge
bracket.)
top). Position it on the left side of the refrigerator and re-
attach with two bolts and a Phillips screwdriver. Place the
refrigerator door down over the pin on the bottom hinge.
Place the washer between the refrigerator door and the
middle hinge and re-attach the hinge pin to the hinge
bracket with a ¼" socket wrench.
.
Flange
Door
Closer/
Stop
Middle Hinge
Bracket