Velleman DEM600 Manual Del Usuario página 4

4. Features
This device can detect stud, metal and unshielded AC live wire. Press
the Mode Switch Button to the desired mode.
STUD SCAN MODE: Three different stud modes for finding wood or
•
metal studs. Choose the right scan modes can help the accuracy of the
scanning. If you don't know the depth of the detection, it is
recommended to use 1⁄2'' scan mode first. When the 1⁄2'' scan mode is
not detected, use 1'' or 1 1⁄2'' scan mode instead.
Stud 1⁄2 inch. Scan Mode: Detects wood or metal studs up to 1⁄2
o
in. (13 mm) deep.
Stud 1 inch. Scan Mode: Detects wood or metal studs up to 1 in.
o
(25 mm) deep.
Stud 1 1⁄2 inch. Scan Mode: Detects wood or metal studs up to 1½
o
in. (38 mm) deep.
•
METAL SCAN MODE: Detects metal up to 2.36 in. (60 mm) deep.
•
AC SCAN MODE: Detects live unshielded AC wires up to 2 inch.
(51mm) deep
5. Overview
Refer to the illustrations on page 2 of this manual.
1 The Center Marking Point
2 Stud Mode Indication
3 Metal Mode Indication
4 AC Mode Indication
AC Wire Warning
5
1⁄2 in.Stud Scan mode
6
7 1 in.Stud Scan mode
6. Battery
1. To replace the battery, make sure the device is switched off.
2. Open the battery compartment at the back.
3. Take out the old battery and replace with a new and identical 9 V
(6F22) battery following the polarity markings inside the compartment.
4. Close the battery compartment.
Low Battery Indicator: When the battery level is low, the screen will
display a low battery icon, indicating that the battery needs to be replaced.
Warning: Do not puncture batteries or throw them in fire as they
may explode. Do not attempt to recharge non-rechargeable
batteries (alkaline). Dispose of batteries in accordance with local
regulations. Keep batteries away from children.
V. 01 – 20/12/2023
DEM600
8 1½ in.Stud Scan mode
9 Power Button
10 Mode Switch Button
11 Scan Button
12 Battery case (Back)
13 Stud direction indication
14 Low Battery Indication
4 ©Velleman Group nv