Taurus SHA2310 Manual Del Usuario página 10

parts or anomalies that may prevent the appliance from operating
correctly.
- Pay special attention when assembling and removing the acces-
sories, as the blades are sharp. Be careful and avoid direct contact
with the blades' cutting edges.
- Do not use the appliance with pets or animals.
- Do not open the batteries under any circumstances whatsoever.
- Recharge the batteries only with the charger supplied by the
manufacturer. A charger that is suitable for one typ of battery may
cause explosion or fire hazard when used with other batteries.
- Use the device only with the batteries for which has been spe-
cifically designed. The use of any other batteries can cause an
explosion or fire hazard.
CHARGING THE BATTERY:
- Charge the battery at an atmospheric temperature of between 4
and 40ºC.
- Connect the power cord (I) to the jack using the socket on the
appliance. The socket is located at the lower part of the appliance.
- Plug the power cord (I) into the mains.
- The battery charge % will blink and the charging icon (3) will be
shown on the LED display (J) to indicate that the charger is char-
ging the battery.
- Approximately 2 hours are needed for a complete charger of the
battery.
- When the battery is fully charged, disconnect the power cord from
the mains supply.
HOW TO CHECK THE BATTERY'S CHARGE LEVEL:
- When you press the On/Off button (E), the LED display (J) will
show the percentage of the battery charge.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has been removed.
- Before using this product for the first time, it is important to make a
full charge of batteries.
USE:
- The appliance can be used directly connected to the mains or by
using his batteries.
- Remove the protective cover (A)