Warnings - OZ Lifting Products OZ500EC Manual Del Operador

Warnings

DO NOT use this hoist as an elevator.
DO NOT lift people or loads over people.
DO NOT leave a load unattended.
DO NOT
operate the chain block in a way that causes the load or the hook block to swing.
DO NOT continuously operate the upper and lower limit slip mechanisms in order to stop the hoist.
DO NOT pull a load at an angle.
DO NOT attempt to invert a suspended load.
DO NOT operate the hoist if it is damaged or if it generates abnormal noise or vibration.
DO NOT carry out electric welding on a suspended load.
DO NOT connect the ground terminal of a welding machine to the load chain.
DO NOT
use the hoist at a voltage other than that for which it is rated.
DO NOT attach the suspended load to another structure or an electric cable.
DO NOT attach the cord of the pushbutton switch unit to another object, or pull on the cord using
a large force.
DO NOT allow the hoist to collide with any end-stops or structure present.
DO NOT wind the load chain directly around the load.
DO NOT allow the load chain to touch sharp edges.
DO NOT allow the chain bag to be thrust up by the load or the sling.
DO NOT use if the warning or caution nameplate or label has been removed or is illegible.
DO NOT attempt to use multiple OZ500EC Hoists for one load.
DO NOT use the hoist while something is touching the body of the hoist, or when body of the hoist
has been fixed.
NEVER use the OZ500EC in excess of its short-time rating, load time efficiency and starting
frequency.
NEVER suspend a load that exceeds the rated load.
NEVER operate the hoist if the load chain is twisted or entangled, cracked or damaged,
is not correctly engaged, is stretched past the specified length or is very worn.
NEVER bring a welding electrode into contact with the load chain.
NEVER use the hoist if the safety latch is broken.
NEVER modify the product or its accessories.
NEVER use parts other than those provided by OZ Lifting Products LLC©
NEVER cut the load chain or extend its length.
NEVER stand or work on a suspended load.
NEVER use the hoist when the load chain is bundled.
ALWAYS switch off the power before carrying out maintenance and inspection or repair.
ALWAYS ground the OZ500EC. This is necessary for preventing the possibility of electric shock.
ALWAYS ensure that the installation location has adequate strength.
ALWAYS give complete attention to operating the load. ̇
ALWAYS move the hoist to a position that is directly above the load before operation.
ALWAYS check the operation of the pushbuttons prior to hoisting.
ALWAYS check the operation of the brake prior to operation.
WARNING: Failure to read and comply with these safety warnings may
result in a hazardous situation that could lead to death, serious injury,
or property damage.
EN pg.11