Descargar Imprimir esta página

DeWalt DWE6411-AR Manual De Instrucciones página 30

Publicidad

Idiomas disponibles

Idiomas disponibles

ENVIRONMENTAL SAFETY
1. Paint should be removed in such a manner as to minimize the
amount of dust generated.
2. Areas where paint removal is occurring should be sealed with
plastic sheeting of 4 mils thickness.
3. Sanding should be done in a manner to reduce tracking of
paint dust outside the work area.
CLEANING AND DISPOSAL
1. All surfaces in the work area should be vacuumed and
thoroughly cleaned daily for the duration of the sanding project.
Vacuum filter bags should be changed frequently.
2. Plastic drop cloths should be gathered up and disposed
of along with any dust chips or other removal debris. They
should be placed in sealed refuse receptacles and disposed
of through regular trash pick-up procedures. During clean up,
children and pregnant women should be kept away from the
immediate work area.
3. All toys, washable furniture and utensils used by children
should be washed thoroughly before being used again.
Tool Care
• Keep your machine as clean as possible by wiping with a clean
cloth and blowing through it with air after every 5 hours of use.
• Don't use harsh chemicals or solvents to clean the tool. These
chemicals could seriously damage the plastic.
• Avoid overloading your sander. Overloading will result in a
considerable reduction in speed and efficiency and the unit will
become hot. In this event, run sander at a "no load" condition for
a minute or two.
• Brush inspection and replacement should be completed by your
local dealer or authorized service center.
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories. An accidental
start-up can cause injury.
Your D
WALT power tool has been designed to operate over a
e
long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air
as often as dirt is seen collecting in and around the air vents. Wear
approved eye protection and approved dust mask when performing
this procedure.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the materials used in these parts. Use a cloth dampened only
with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
personnel, always using identical replacement parts.
Accessories
WARNING: Since accessories, other than those offered by
D
WALT, have not been tested with this product, use of such
e
accessories with this tool could be hazardous. To reduce the risk of
28

Publicidad

loading

Este manual también es adecuado para:

Dwe6411Dwe6411-brDwe6411-b3Dwe6411-b2