Publicidad
Idiomas disponibles
Idiomas disponibles
6
SAFETY INSTRUCTIONS
Operation
• Read all instructions before using the appliance.
• Do not dry articles that have been previously
cleaned in, washed in, soaked in, or spotted with
gasoline, dry-cleaning solvents, or other flammable
or explosive substances, as they give off vapors
that could ignite or explode.
• Do not reach into the appliance if the drum is
moving.
• Do not allow children to play on or in the appliance.
Close supervision of children is necessary when
the appliance is used near children.
• Do not use fabric softeners or products to eliminate
static unless recommended by the manufacturer of
the fabric softener or product.
• Do not use heat to dry articles containing foam
rubber or similarly textured rubber-like materials.
• Do not tamper with controls.
• Always check the inside of the dryer for foreign
objects. Failure to follow these instructions may
result in fire or death.
• Do not store plastic, paper, or clothing that may
burn or melt on top of the dryer during operation.
Failure to follow these instructions may result in fire
or death.
• Be careful when opening and closing the door.
Fingers and hands can get caught in the door and
cause injury if the door drops forward unexpectedly.
• Do not place heavy items on or lean against the
top of the door when it is open.
• Do not attempt to pull the hamper door open
more than 40 degrees. The dryer could tip
forward, causing injury or damage.
• Do not place items on the top of the dryer.
• Gas appliances can cause minor exposure to four
potentially hazardous substances, namely benzene,
carbon monoxide, formaldehyde, and soot, caused
primarily by the incomplete combustion of natural
gas or LP fuels.
• Properly adjusted dryers will minimize incomplete
combustion. Exposure to these substances can be
minimized further by properly venting the dryer to
the outdoors.
• Do not place items exposed to cooking oils in your
dryer. Items contaminated with cooking oils may
contribute to a chemical reaction that could cause a
load to catch fire.
To reduce the risk of fire due to contaminated loads,
the final part of a tumble dryer cycle occurs without
heat (cool down period). Avoid stopping a tumble
dryer before the end of the drying cycle unless all
items are quickly removed and spread out so that
the heat is dissipated.
• Do not let children or pets climb inside the dryer
drum.
• Do not put living animals such as pets inside the
product.
SAVE THESE INSTRUCTIONS
• Do not put any part of your body, such as your
hands or feet, or metal objects under the product.
• Do not let your hand get pinched when opening or
closing the dryer door.
Steam (steam model):
• Do not open the dryer door during steam
cycles. Failure to follow these instructions may
result in a burn hazard.
• Do not dry articles that have been previously
cleaned in, washed in, soaked in, or spotted
with gasoline, dry-cleaning solvents, or other
flammable or explosive substances as they give
off vapors that could ignite or explode. Failure to
follow these instructions may result in fire or death.
• Do not fill the steam feeder with gasoline,
dry cleaning solvents, or other flammable or
explosive substances. Failure to follow these
instructions may result in fire or death.
• Do not touch the steam nozzle in the drum
during or after the steam cycles. Failure to follow
these instructions may result in a burn hazard.
• Do not fill the steam feeder with hot water (over
86 °F/30 °C). Failure to follow these instructions
may result in a burn hazard.
Maintenance
• Do not repair or replace any part of the appliance
or attempt any servicing unless specifically
recommended in the user maintenance instructions
or in published user-repair instructions that you
understand and have the skills to carry out.
• Clean the lint filter before or after each load.
• The interior of the appliance and exhaust duct
should be cleaned periodically by qualified service
personnel.
• Before the appliance is removed from service
or discarded, remove the door to the drying
compartment.
• Certain internal parts are intentionally not grounded
and may present a risk of electronic shock only
during servicing.
Service personnel - do not contact the following
parts while the appliance is energized: CONTROL
BOARD
Publicidad
