Publicidad
Idiomas disponibles
Idiomas disponibles
24. If the electric pruning shears are not used for a long time, the battery needs to be charged for storage.
refueling
BLADE
Please cut off the power source of the shears before operation.
Refuel lubricating oil before using the blade or after it is used for more than 4h.
For correct refueling mentioned above, the blade needs to be opened.
Refueling steps:
1. Fueling hole in the pin hole of the blade on the back of the shears.
Squeeze the lubricating oil from the oil bottle into the fueling hole and cut nothing for several times to make
the lubricating oil evenly distributed.
TIGHTNESS
Be sure to cut off the power source between the shears and the battery pack
before operation.
Check the tightness of the blade before use. A blade with proper tightness will not swing left and right. Proper
tightness of the blade will make it labor-saving when pruning using the shears.
Caution: When the blade is closed, the blade should not have a lateral swing. Lateral swing is an abnormal
state, given it will create a gap between the two blades and causes the teeth of the gears to not properly mesh,
thus damaging the mechanical structure.
REPLACE
Please cut off the power source of the shears before operation.
When the entire length of the moving blade no longer coincides well with the fixed blade, or if the blade after
grinding is still not clean after cleaning, it is recommended to replace the blade. The replacement steps are
as follows:
1. For safety, please power off before replacement and remove the battery.
2. Follow the steps below to replace the blade.
3. After the replacement, clean it, connect the battery, check the power and close the blade.
adjustment of the blade
the blade.
Refueling place of
lubricating oil
INSTRUCTIONS
EN
47
Publicidad
