Celexon Economy eAdjust-71121 Manual De Instrucciones página 16

STEP 2: MOUNTING THE SUPPORT STRUT
Fit the support strut (4) to the columns
(2) & (3) (according to the drawing).
Use the screws (B) and tighten them
with the Allen key (C). Ensure that the
support strut is set at a sufficient width
for the tabletop width used. Then
screw the previously loosened screws
in the support strut with the allen key
(C) again.
STEP 3: MOUNTING THE GEAR ROD
Install the gear rod (5) on the columns (2) & (3).
Align
Loosen
Insert
Insert Tighten
Tighten
Make sure you only do 1/3 of a turn to tighten.
5