Beamz MAGIC 2 Manual Del Usuario página 6

Please consider the respective national norms during the installation! The installation must only be carried out by an authorized
employee or dealers!
This fixture has been designed to be hung. It is recommended for safety purposes, your lighting effect are properly mounted using a suitable hanging
clamp and safety cable. Items appropriate for safe and effective mounting are easily sourced from your lighting vendor.
International laser safety regulations require that lasers must be operated in the fashion illustrated below, with a minimum of 3 meters (9.8 ft) of vertical
separation between the floor and the lowest laser light vertically. Additionally, 2.5 meters of horizontal separation is required between laser light and
audience or other public spaces.
Use of controls, adjustments, or performance of procedures other than what is specified herein may result in hazardous radiation
exposure!
• The installation of the fixture has to be built and constructed in a way that it can hold 10 times the weight for 1 hour without any harming
deformation.
• Always use the supplied mounting bracket to hang the fixture.
• The fixture should aid of a mounting bracket (not included) to the supplied mounting bracket to be confirmed.
• The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This secondary safety attachment
must be constructed in a way that no part of the installation can fall down if the main attachment fails.
• Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert before taking into operation
•
for the first time and after changes before taking into operation another time.
• The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
• The fixture should be installed in the position where persons cannot reach.
• For your own safety and for others, we do strongly recommend you to use this laser emergency kill switch.
(ref.no: 152.958)
When installing the device, make sure there is no highly in inflammable material (decoration articles, etc.) in between a distance of
min 0.5 meter.
Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to
the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all
other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No
dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
Follow below advice to enjoy a longer laser lifetime:
• Quick on/off switching of this device will reduce durability of the laser diode dramatically.
• Ensure that device does not get overheated:
Switch off device when it is not needed. Diodes are switched on and can wear out even if
o
there is no visible laser output.
Switch off device after 1 hour and let the laser cooling down for 15 minutes.
o
Ensure that the fans and heat sinks are free of dust and dirt.
o