Descargar Imprimir esta página

Climadiff CPF100B1 Manual De Utilización página 50

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

- Press
and
increase/decrease by 1°C with each press of the buttons.
- Press
and
- Press
and
including 3 working LED lights will be off, but the wine cooler is still working. Press any key to stop
standby mode.
Tip: immerse a suitable thermometer in a clear glass bottle filled with water and place it in the
middle of the cellar. Wait at least 24 hours before checking the temperature. Then adjust the
thermostat in the light of the temperature read and that required.
Note: when you wish to switch from a single compartment wine cellar with multi temperature
(when fan is not activated) to a single compartment wine cellar with mono temperature (when
fan is activated and homogenizes the internal temperature), or vice versa, it is necessary to wait
72 hours before the inner temperature of the wine is correctly regulated and becomes stabilized.
When the surrounding temperature is 25℃ and the wine cooler has no bottle loaded, it will take around
1h to increase the wine cooler's temperature from 5℃ to 12℃. Under the same circumstance, it will take
around 2h30 to decrease the wine cooler's temperature from 12℃ to 5℃. The less the temperature span
is, the less time it will take. The setting temperature of upper zone should be lower than the setting
temperature of lower zone
6. ÉQUIPMENT
The climate control system
According to advice from specialists, the ideal temperature for storing wine is around 12°C, within a
bracket of 10 to 14°C. Do not confuse this with service temperature, which varies between 5 and 20°C,
depending on the specific nature of the wine.
It is especially important to avoid sudden changes in temperature. Designed by specialists for oenophiles,
this appliance, unlike a simple refrigerator, takes into account the sensitivity of grand cru wines to sudden
variations in temperature by ensuring the close control of a constant average temperature.
The anti-vibration system
The refrigeration compressor is equipped with special dampers (silent-blocks) and the inner space is
insulated from the body by a thick layer of polyurethane foam. These characteristics prevent the
transmission of vibration to your wines.
Defrosting
Your appliance is equipped with an automatic defrost cycle. When a cooling cycle finishes, the appliance's
refrigerated surfaces are defrosted automatically. The defrost water is channeled into a condensates
evaporation tray which is located in the back of the appliance near the compressor. The heat produced
by the compressor then evaporates the condensates collected in the tray.
buttons to adjust temperature of wine cooler. The temperature selected will
together for 5 seconds to change Celsius to Fahrenheit.
together for 5 seconds to enter standby mode. Under standby mode, all displays
50

Publicidad

loading