Initial Set Up And Operation; Important Operating Instructions; Power Level Switch - VOSS.farming easyCUT Instrucciones De Uso

de en fr
ca 1,5 to 2 mm
mains must match. Additionally, only alternating current may be used.
- Blades must be properly installed. The clipper must not be operated without them.
- Avoid any contact with the moving blades. Even when the clipping machine is swit-
ched off, the blades must not be touched until the clipper is completely disconnected
from the power supply.
- Avoid any contact of the machine with liquids during storage or clipping. Do not clip
wet animals. Liquid and moisture in the machine reduces electrical insulation and in-
creases the risk of electric shock or short circuit. The machine should only be cleaned
with a dry cloth or brush.
- Cables can also be dangerous. Lay them securely so that neither humans nor animals
can trip over them or step on them. Keep the cables away from heat sources.
- Do not wrap the cable around the machine as it may cause insulation breakage and
cable damage. Check the cable regularly for damage.
- Before unplugging the clipper make sure it is switched off.
- Never shear with damaged or blunt blades. Only use original blades.
- The sound of the clipper can unsettle animals. They may kick or injure themselves, so
secure the animal sufficiently beforehand.
- Make sure that unauthorised persons are not present in the clipping area.
- Choose well ventilated rooms and never near objects or gases likely to explode.
- Do not insert foreign objects into openings on the machine.
5b. Power level switch
The clipper has 2 power levels. We recommend the first stage for sensitive, frightened
animals or sensitive areas. The second stage is suitable for regular shearing.
Before plugging the machine into a power outlet, make sure that the switch is set to 0
(switched off).
it nl sv

5. Initial set up and operation

5a. Important operating instructions
The following measures serve to avoid
problems and accidents and should
always be followed:
- Use the clipper for approx. 30 minutes
- The voltage on the nameplate and in the
es
and then let it rest for 10 minutes.
This protects the machine and blades
and increases service life.
17