Maintenance; Troubleshooting - VOSS.farming easyCUT Instrucciones De Uso

de en fr

8. Maintenance

Prior to performing maintenance make sure the clipper is switched off and completely
disconnected from the power supply.
Cleaning:
After clipping, remove the oil from the machine, head and blades with a dry cloth and
remove hair with a brush. Then lightly oil all parts to prevent rust build-up. Even the
smallest rust spots can impair the clipping result. The assembly of the blades is descri-
bed in point 4.b. Fitting blades.
Blade sharpening:
Sharpening can only be done on special machines and by specialist dealers. Work only
with sharp knives, never with blunt or damaged knives.
Storage:
The clipper must be kept well cleaned and oiled. Place the case out of the reach of child-
ren and animals and in a moisture-free environment. If there is
a suspicion of ingress of moisture, do not use the machine any more. Bring them for
inspection as there is a risk of a short circuit or electric shock.
Cleaning the clipper head:
The clipper head must also be cleaned regularly. First, remove the blades. Then loosen
the two screws and remove the head from the drive. Now you can thoroughly clean the
head inside as well as all individual parts. If you reassemble it afterwards, you should
oil it again (lubrication is described in section 3).

9. Troubleshooting

Motor
Problem
Motor does not run · no current
Motor gets hot
it nl sv
Cause
· cable defective
· switch or motor defec-
tive
· air filter is blocked
· blade tension is too
high
· defective ball bearing
· blades or clipper head
run dry
es
Solution
· check socket and fuse
· have checked /replaced by a specialist
· have it replaced by a specialist work-
shop
· clean or replace air filter
· slightly loosen the tensioning nut;
if the blades still do not cut please
sharpen them
· have replaced by a specialist workshop
· lubricate
19