cecotec CONGA ROCKSTAR 2500 THUNDER JALISCO Manual De Instrucciones página 49

4. Vacuum and shake the filter to remove every particle and dirt remain that may block them
and hinder proper air circulation. Remember not to use the vacuum cleaner without the
filter properly assembled. Filters cannot be washed inside a washing machine nor dried
with a hair dryer. Do not brush the high-efficiency filter.
5. Put the filters back into the filtering system.
6. Put the filtering system back into the dirt tank.
7. Put the dirt tank back into the appliance.
Cleaning the brush attachment
- Slide the brush release button with your finger and remove the side cover.
- Remove the brush.
- It is important to remove any dirt that may have deposited in the brush inlet.
- If you decide to wash the brush, all parts must be left to dry. Assemble the pieces back in
order to use the brush again.
Removing the battery
Press the battery release button and remove it. Store the battery in a dry place.
Storing the vacuum cleaner
If the robot is not going to be used for a long time, remove the battery and store it in a dry and
safe place.
6. TROUBLESHOOTING
Problem
The vacuum
cleaner does not
work.
The suction power
decreased and the
vacuum cleaner
makes a lot of
noise.
Possible cause
Battery is discharged.
The suction tube, brush, battery, or
the appliance itself are not correctly
positioned.
The dirt tank is full.
The filter is too dirty, the brush inlet is
clogged, or the brush is blocked.
Possible solution
Charge the vacuum
cleaner.
Make sure all parts of
the vacuum cleaner are
correctly assembled.
Empty the dirt tank and
clean the filtering system.
Empty the dirt tank and
clean the filtering system,
brush inlet, and brush.
CONGA ROCKSTAR 2500 THUNDER JALISCO
ENGLISH
49