cecotec TV LED A3 ALH30032 Serie Manual De Instrucciones página 110

ENGLISH
Basic usage
Switching the TV on or putting it on standby
- This TV is switched on or in standby mode. It cannot be switched off completely. If you are
not going to use the TV set for a long period of time, unplug it from the wall socket.
To turn on the TV
- Make sure that the mains plug is plugged in.
- Press the (Power) button on the remote control or the control button on the back or
bottom of the TV (depending on the model). Power indicator goes out.
To put the TV in standby
Press the (Power) button
of the TV for a few seconds. The power indicator turns red (colour may vary depending on the
model).
Source selection
- Once the external systems are connected to your TV, you can switch between the different
input sources.
- Press the button on the remote control.
- Then use the buttons
button on the remote control to confirm it.
Volume setting
- Press the VOL+ or VOL- buttons on the remote control to adjust the volume to your
preference.
- If you want to mute the sound, press the (Mute) button
again to cancel this function.
Programme selection
- Press the P+ or P- buttons on the remote control to change channels.
- You can go directly to the TV channel of your choice by pressing the 1, 2, 3... buttons on the
remote control. buttons on the remote control.
- To select channel 12, for example, press key 1 followed by key 2.
Display of the channel list
While watching a channel, press the LIST button to display the list of memorised channels.
Access to the HOME menu Fig. 14
After connecting the TV to the Internet, press the button
the HOME menu and access the Smart TV functions. Press
one of the available applications and press OK button to confirm.
110
TV LED A3 SERIES ALH30032 / ALH30032S
on the remote control or the control button on the back or bottom
on the remote control to highlight an entry and press the OK
on the remote control. Press
on the remote control to display
, , or buttons to select