Publicidad
Idiomas disponibles
Idiomas disponibles
CLEAN Setting
Your grill is equipped with an innovative CLEAN setting that
allows for hassle-free grill cleaning. The high heat generated
from the burners will turn all remaining food debris to ash.
Follow these steps:
After you are done grilling, adjust all main burners to CLEAN
Ÿ
setting, close lid and remain for approximately 12 – 15
minutes.
After approximately 12 – 15 minutes, adjust all main burners
Ÿ
to OFF setting and allow grill to cool.
Once the grill is cool, open lid and use a nylon-bristle
Ÿ
cleaning brush to remove any remaining debris and dispose
of the ash.
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1. Turn gas off at control knobs and LP cylinder.
2. Remove cooking grates and heat tents.
3. Remove carryover tubes and hardware securing burners.
4. Detach electrode from burner.
NOTE: Removal/Detachment method will depend on the
burner configuration. See different configurations in
illustrations below.
5. Carefully lift each burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use
the one easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well)
into a small hook. Run the hook through each burner
tube several times.
(B) Use a narrow bottle brush with a flexible handle (do not
use a brass wire brush). Run the brush through each
burner tube several times.
(C) Wear eye protection: Use an air hose to force air into
the burner tube and out the burner ports. Check each port
to make sure air comes out each hole.
6. Wire brush entire outer surface of burner to remove food
residue and dirt.
7. Clean any blocked ports with a stiff wire such as an open
paper clip.
8. Check burner for damage due to normal wear and corrosion,
some holes may become enlarged. If any large cracks or holes
are found, replace burner.
VERY IMPORTANT: Burner tubes must reengage
valve openings. See illustrations at right.
Correct burner-to-
valve engagement
9. Attach electrode to burner.
10. Carefully replace burners.
11. Attach burners to brackets on firebox.
12. Reposition carryover tubes and attach to burners. Replace
heat tents and cooking grates.
13. Before cooking again on grill, perform a "Leak Test" and
"Burner Flame Check".
Firebox
Firebox Burner
Support
Firebox
Page 10
Electrode
Electrode
Pry off electrode
Firebox Burner
with a flat blade
Support
screwdriver
Remove
screws
Publicidad
